Publicidad
Idiomas disponibles
Idiomas disponibles
Palmgren Operator's Manual
D D E E S S C C R R I I P P T T I I O O N N
Palmgren 6" Milling Angle Vise permits
accurate positioning at any angle from 0°
to 45°. Moving jaw and leadscrew are
ground for smooth operation. Graduated
swivel base allows vise to be rotated 360°
and locked at any desired angle.
S S A A F F E E T T Y Y R R U U L L E E S S
• Understand and obey all safety instruc-
tions supplied with drill press, mill, or
other machines on which vise is used.
• Bolt or clamp vise to work surface in
desired location by securing both
mounting flanges located on swivel
base.
• Be sure workpiece is clamped securely
between jaws before starting machin-
ing operation.
• Do not over tighten—vise can develop
a large clamping force. Use only force
which is needed.
• Do not pound or hammer on work-
piece. This vise is designed to clamp
the workpiece in a desired position for
machining operations only.
D D I I M M E E N N S S I I O O N N S S
Refer to Figure 1.
Stock No.
Jaw Width
A
Throat Depth
B
Jaw Opening
C
Overall Height
H
Base Length
L
Swivel Base Width
W
W
A
H
Figure 1 - Dimensions
O O P P E E R R A A T T I I O O N N
Refer to Figure 2.
• Mount vise to work surface in desired
location by securing both mounting
flanges located on swivel base (Ref.
No. 26)
• Rotate vise to desired position. A scale
and indicator are provided for refer-
ence. Tighten two hex nuts (Ref. No. 22)
to secure base (Ref. No. 1) to swivel
base (Ref. No. 26).
• Open jaws of vise and place workpiece
between jaws in desired position.
Secure workpiece between jaws by
rotating leadscrew (Ref. No. 20) with
handle (Ref. No. 21). Be sure workpiece
22604
is held securely in vise before starting
6"
machining operation.
2"
ANGLE ADJUSTMENT
6"
• Loosen six bolts (Ref. No. 5).
7
1
/
"
4
• Use scale on the flange (Ref. No. 7) to
18
3
/
"
4
set vise at desired degrees from hori-
11
1
/
"
2
zontal.
• Tighten six bolts to lock angle position.
2
22604
C
B
L
Publicidad
