Publicidad
Idiomas disponibles
Idiomas disponibles
Status indicator
Moisture display
1. Drywall
Green range:
1%~16%: dry
Yellow range:
16.1%~28%: slightly wet
Red range:
28.1%~50%: very wet
2. Cement board
Green range:
1%~16%: dry
Yellow range:
16.1%~28%: slightly wet
Red range:
28.1%~50%: very wet
3. Soft wood
Green range:
1%~16%: dry
Yellow range:
16.1%~28%: slightly wet
Red range:
28.1%~50%: very wet
4. Hard wood
Green range:
1%~16%: dry
Yellow range:
16.1%~28%: slightly wet
Red range:
28.1%~50%: very wet
5. Mildew indicator
The higher the mildew display on the lower bar diagram, the greater the risk of mildew formation.
Calibration
The device has an automatic calibration function. To calibrate the device, hold it at a distance of at
least 50 cm from all objects and press the HOLD button for 3-5 seconds until the "CAL" display
Calibration is complete after a few seconds, and the exact humidity value is shown.
appears.
Note
If the meter cannot be switched on or the battery level display is only showing one bar, the batteries
must be replaced.
Dispose of used batteries in the proper manner via the established collection points.
The moisture value of wood depends on the ambient conditions and wood density. To achieve an
exact result, it is crucial that you select the correct surface to be measured. In any case, several
measurements should be carried out at various places on the corresponding material.
Cleaning and maintenance
•
Remove the batteries before cleaning the device.
•
Clean the device only with a dry cloth and do not use any cleaning agents as these may corrode
the housing.
•
If the device is not used for a long period of time, remove the batteries.
•
When inserting batteries, ensure the correct polarity.
•
Do not expose batteries to high temperatures and do not throw them into fire.
•
Observe your country's regulations regarding the correct disposal of used batteries
GB - 10
Publicidad
