Orbis VIARIS UNI Manual De Usuario página 59

SMART CHARGER INSTALLATION
Security warnings
The following instructions must be observed during installation and
operation of equipment:
 The equipment must be installed by authorised and qualified person-nel who
comply with the instructions of this manual.
 The equipment must be installed and activated in compliance with the current
low voltage regulations.
 Do not use the equipment for purposes other than that specified.
 Before installing the smart charger, check that it is not damaged.
 Before accessing the connecting terminals, verify that the cables are not under
electric voltage. The opening of the enclosure does not im-ply the absence of
tension within it. It may only be opened by authorised and qualified personnel.
 In accordance with the applicable regulations, the installer should check
whether overvoltage protection measures are necessary.
 Use only the specified charging cable for each electric vehicle. In no case
should another type of extension cable be used.
 In case of malfunction, do not perform repairs and contact our Technical
Services immediately.
 After installation, inaccessibility to connecting terminals without ap-propriate
tools should be ensured.
 To protect the intelligent charger against potential vehicle impacts, the instal-
lation of a protective barrier is recommended.
 In the event that your charger has an outlet with a connection cable, cover
the connector with its supplied rubber cover to prevent the entry of water.
Assembly requirements
 The minimum installation height of the power outlets and connectors should be
0.6 m above ground level. If the charger is intended for pub-lic use, the maxi-
mum height shall be 1.2 m and in places for persons with reduced mobility, be-
tween 0.7 m and 1.2 m. (See the instructions of the country where the installa-
tion is carried out in case other heights are specified).
 The mounting plate must be located at a height between 0.4 m and 1.5 m
above ground level.
 The charger must be installed upright and allow clearance for maintenance.
 Use seals or presses to ensure the level of IP protection of the charger.
58