BENYAR BY-5160 Guía De Configuración página 4

BY BENYAR
STOPWATCH:
The stopwatch is capable of measuring:
1/10 seconds elapsed up to one second (top eye). Minutes elapsed up to one hour (bottom eye).
Seconds elapsed up to one minute (middle eye)
BEFORE USING THE STOP WATCH, reset the stopwatch hands to the "60" and "0" positions.
To reset stopwatch hands:
1.
PULL crown to position "3".
2.
PRESS pusher "A" intermittently until the top eye hand is reset to "0".
3.
PRESS pusher "B" intermittently until the middle and top eye hands is reset to "60".
Note:
PRESSING and HOLDING either pusher "A" or "B" will cause the hands to continue to move until the pusher
is released.
If the stopwatch hands move improperly:
1.
PULL out the crown to "2" position.
2.
PRESS pushers "A" & "B" simultaneously for three seconds.
3.
RELEASE pushers, stopwatch hands will move 180 degrees.
4.
PUSH crown in to "1" position.
Standard stopwatch measurement:
1.
PRESS pusher "A" to start timing.
2.
PRESS pusher "A" to stop timing.
3.
PRESS pusher "B" to reset.
Timing 2 competitors:
1.
PRESS pusher "A" to start timing.
2.
PRESS pusher "B" to stop timing.
3.
PRESS pusher "A" to stop timing of second event.
4.
PRESS pusher "B" to view time of second event.
5.
PRESS pusher "B" to reset.
Split time:
1.
PRESS pusher "A" to start timing.
2.
PRESS pusher "B" to split.
3.
PRESS pusher "B" to begin again.
4.
PRESS pusher "A" to stop.
5.
PRESS pusher "B" to reset.
BY-5160)
(Model:
Watch Setting Guide