Imetec R1504 Instrucciones De Uso página 20

lf there are such signs or in the case of malfunction, contact an authorised technical
service centre.
EN
This chapter describes the most common problems that can arise using the appliance. If
the problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem
The LEDs on the control unit do
not light up.
The blue warning light is
flashing.
Temperature LED 1 (11) is
flashing.
The product has been used
incorrectly or is damaged.
The power cable or another
internal wire is damaged.
The control unit is damaged.
There are holes or tears in the
fabric or stubborn creases that
do not spread out.
The packaging of the appliance is made of recyclable materials. Dispose of the packaging in
accordance with the environmental protection regulations.
Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), the
19
TROUBLESHOOTING
Check that the control unit plug is fully inserted in the
socket (3). If the LEDs remain off, remove the control
unit plug from the socket (3) and return the under-
blanket to an authorised technical service centre.
Turn the control unit off and remove the plug from
the socket (3). Check that the control unit connector
(2) is fully inserted in the underblanket connector (1)
and reinsert the plug in the socket (3). If the standby
LED continues to flash, return the underblanket to an
authorised technical service centre.
Return the underblanket to an authorised technical
service centre to be checked.
DISPOSAL
Solution