Rear Panel Features; Lcd Features - Numark MP103 USB Guia De Inicio Rapido

REAR PANEL FEATURES

3
1. VOLTAGE SELECTOR -- - Set this switch to the voltage for your location.
2. POWER PLUG CONNECTOR – Plug your supplied power cord in here.
3. BALANCED OUTPUTS (XLR) – Connect your CD player to your mixer from these balanced XLR outputs.
4. LINE OUTPUTS (RCA) – Connect your CD player to your mixer from these line-level outputs.
5. DIGITAL OUTPUT – This RCA connector will allow you to send a digital audio signal to any device designed to accept a
S/PDIF (Sony/Phillips Digital Interface Format) signal. You can also connect the digital output to a karaoke decoder to
reproduce the graphics from CD+G discs.

LCD FEATURES

1. PLAY – This shows when the unit is playing.
2. CUE – Lit continuously when the unit is paused at a
cue point.
3. CD / USB – Indicates whether you are playing tracks
from a loaded CD or a connected USB device.
4. TRACK / FOLDER NUMBER – Shows the current
track or folder number. When viewing or playing a
program, the number will have a "P" in front of it
("P01," "P02," etc.), indicating the number of that
track in the program.
5. TOTAL TRACK – Displays the total number of tracks available on the CD or USB device. (When in Folder View, it will
display the total number of folders available on the USB device.)
6. MINUTES – Shows the minutes elapsed or remaining depending on mode setting.
7. SECONDS – Shows the seconds elapsed or remaining depending on mode setting.
8. FRAMES – The CD player breaks down a second into 75 frames for accurate cueing. This shows the frames elapsed or
remaining depending on mode setting.
9. TIME MODE – Indicates whether the time shown on the LCD is the elapsed time for the track, remaining time for the
track, or total remaining time for the entire CD.
10. TIME BAR – Shows either time remaining or elapsed depending on the setting of the TIME button.
11. PLAY MODE – Shows when the unit is set to Single Mode (the deck will stop at the end of each track) or Continuous
Play Mode (the entire disc will be played without interruption). This function is controlled by the SINGLE button.
12. RELOOP – Indicates when a loop is programmed.
13. BPM – Displays the tempo in BPM (beats per minute) of the current track. When "AUTO BPM" is displayed, it is a
tempo that has been automatically detected.
14. PITCH – Shows the percentage change in pitch.
15. MT (MASTER TEMPO) – Indicates that the MASTER TEMPO button is engaged.
16. PG (PROGRAM) – Indicates that a program is playing.
17. TEXT DISPLAY – Displays the folder name or file name when navigating MP3s.
18. iD3 TAG – Displays what kind of iD3 tag is shown in the TEXT DISPLAY.
4
3
5
4
1
11
Single Cont. Elapsed Total Remain
TRACK
4
FOLDER
2
Total
3
TITLE
ALBUM
ARTIST
5
18 17
6
6
2
1
9
14
10
RELOOP
MT
PG
13
8
7
12
15
16