Black and Decker PW1500 Manual De Instrucciones página 11

TROUBLESHOOTING GUIDE - continued
Symptom
Spray wand or
extension leaks.
Pump is excessively
noisy.
Water leaks from
pump.
Oil leak.
Motor buzzes but
fails to run.
Cause
Broken O-ring.
Pump is sucking air.
Loose fittings.
Water seals are damaged
or worn.
Oit seals are damaged or
worn.
Supply voltage below
minimum.
System has residual
)ressure.
Voltage toss due to
extension cord.
Cleaner not used for long
)eriods.
Solution
Contact B&D Customer Service
Representative at 1-800-544-6986.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges from the
nozzle.
Check that all fittings are tight.
Contact B&D Customer Service
Representative at 1-800-544-6986.
Contact B&D Customer Service
Representative at 1-800-544-6986.
Verify that only the pressure washer is
running on this circuit.
Turn unit off, squeeze trigger on spray
wand to release pressure, then turn
unit on.
Do not use extension cord with this
unit - plug directly into outlet.
Contact B&D Customer Service
Representative at 1-800-544-6986.
,t,I