Electro Depot HIGH ONE DC 8 B FD W566C Instrucciones De Uso página 13

C
Useful information
CAUTION:
• Empty the tank after each use. If it reaches its maximum
capacity during a drying program, the program is paused
and the " " icon flashes.
• Once the tank is empty, the dryer can be restarted by
pressing the [Start/Pause] button.
• Do not drink the condensation water.
• Do not use the dryer without the tank.
Troubleshooting
Problem Cause
"E30" Heating problem
"E32" Problem with the humidity sensor
"E33" Problem with the temperature sensor
22
Solution
Contact your local
support service if the problem
persists.
EN
C
Useful information
CAUTION : Repairs may only be conducted by authorised
technicians.
• Before contacting the customer service, make sure you
assess the problem yourself beforehand and properly
adhere to the instructions.
• Even if the problem is covered by the warranty, you will be
charged for the technician's advice.
Problem
The display screen does not light up.
XXX lights up.
XXX lights up
The dryer does not start.
Drying is not optimal or the drying time is too long.
CAUTION :
If you cannot resolve the problem by yourself and need help:
• Press the [On/Off] button.
• Disconnect the mains plug and contact the customer
service
23
Solution
• Check the electricity supply.
• Check that the plug is properly connected.
• Check the selected program.
• Press the [On/Off] button.
• Empty the water tank.
• If the symbol stays lit, call the customer service.
• Clean the heat exchanger.
• Clean the lint filter.
• Make sure the door is properly closed.
• Check that the program is correctly selected.
• Make sure that the start button has been properly
activated.
• Clean the lint filter and heat exchanger.
• Empty the tank.
• Check the drain hose.
• The location where the dryer is installed is too confined.
• Clean the humidity sensors.
• Keep the air inlet clean.
• Use a program with a higher drying level or longer time
setting.
EN