Publicidad
Idiomas disponibles
Idiomas disponibles
Your PROLINE EZ® RO system is equipped with EZ fittings. The quick connect fittings feature leak proof
installations. EZ Fittings provide efficient quick connection and disconnection resulting in reduction of
service time and labor cost.
1 Cut tubing square
2 Insert tube
3 Push up to tube stop
4 Pull to check secure
Push in collet and remove tube
Disconnecting
EZ FITTINGS- QUICK CONNECT
Push on collet
Pull on tubing
Pull on tubing
Pull on tubing
Cut the tube square. It is essential that the outside
diameter be free of score marks and that burrs and
sharp edges be removed before inserting into fittings.
For soft thin walled plastic tubing, we recommend the
use of a tube insert.
Fitting grips before it seals. Ensure tube is pushed into
the tube stop.
Push the tube into the tube stop. The collet (gripper)
has stainless steel teeth which hold the tube firmly in
position while the o-ring provides a permanent leak
proof seal.
Pull on the tube to check that it is secure. It is a good
practice to test the system prior to leaving site and/or
before use.
To disconnect, ensure the system is depressurized
before removing the tube. Push in collet squarely
against face of fitting. With the collet held in the
position, the tube can be removed. The fitting can
there be re-used.
9
Publicidad
