Publicidad
Idiomas disponibles
Idiomas disponibles
English
Intended use
Measure, monitor, and trend body temperature of adult and pediatric patients.
WARNINGS
1.
To reduce the risks associated with access to critical patient information or
equipment:
• The SpotOn control unit is to be attached to other equipment by
authorized service personnel only.
• Do not re-install or re-locate the SpotOn control unit.
2.
To reduce the risks associated with hazardous voltage, fire, and thermal energy
hazards:
• Use ONLY with 3M SpotOn system components (sensors, cables, and
power supply). Do not substitute other devices for the SpotOn control
unit, sensor, cables, or power supply.
• Do not use the SpotOn temperature monitoring system (sensor, control
unit, cables, or cords) in an MRI environment.
3.
To reduce the risks associated with hazardous voltage and fire:
• Keep power supply visible and accessible at all times. The plug on the
power supply serves as the disconnect device. The power outlet shall be as
close as practical and shall be easily accessible.
• Use only the power supply specified for this product and certified for the
country of use.
• Use only a properly grounded power outlet; do not use extension cords or
multiple portable socket outlets.
• Do not allow the power supply to get wet.
• Do not use the SpotOn control unit when it appears the unit or system
components are damaged. Contact 3M Patient Warming technical
support at 1-800-733-7775 or 952-947-1200.
• Do not service or modify the power supply, control unit, cables, sensor, or
any part of the 3M SpotOn system. There are no user serviceable parts.
4.
To reduce the risks associated with fire:
• This system is not suitable for use in the presence of a flammable
anesthetic mixture with air nitrous oxide.
5.
To reduce the risks associate with pressure, and crushed or entangled cords
and connectors:
• Do not allow the patient to lie on any SpotOn sensor cable or connector.
• Always position cables and cords away from the patient's body.
• Do not use a headband or other device to secure the SpotOn sensor to
the patient.
6.
To reduce the risks associated with incorrect system or sensor use:
• Limit use of the SpotOn temperature sensor to 24 hours. Extended use
may compromise skin, cause degradation of material or performance.
• Avoid exposing the SpotOn temperature sensor, sensor cable, power
supply, and control unit to surgical skin surface preparation solutions or
other fluids.
• Use an additional independent thermometer to measure body
temperature during intentional hyperthermia or hypothermia therapy.
• Confirm unanticipated temperature reading with an independent
thermometer, if needed.
• Do not reposition the SpotOn temperature sensor; repositioning may
-2-
Publicidad
