Resetting To The Factory Default Settings; Access From The Internet; Further Information - Axis P8221 Guia De Instalacion

Page 18

Resetting to the factory default settings

This will reset all parameters, including the IP address, to the factory default settings:
1. Disconnect the power from AXIS P8221, or if PoE is used disconnect the network cable.
2. Press and hold the Control button (see page 4) and reconnect power or the network cable if PoE
is used.
3. Keep the Control button pressed until the Status indicator displays amber (this may take up to
15 seconds).
4. Release the Control button. When the Status indicator displays green (which can take up to 1
minute) the process is complete and the device has been reset.
5. Re-assign the IP address, using one of the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web interface.
For more information, please see the online help or the User's Manual.

Access from the Internet

Once installed, your AXIS P8221 is accessible on your local network (LAN). To access AXIS P8221
from the Internet, network routers must be configured to allow incoming traffic, which is usually
done on a specific port
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for playing audio streams
Please refer to the documentation for your router for further instructions. For more information on
this and other topics, visit Axis Support web at www.axis.com/techsup

Further information

The User's Manual is available from Axis web site at www.axis.com.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your AXIS
P8221. To see the currently installed firmware version, see the About web page in the
device's Setup tools.
AXIS P8221 Installation Guide