Install The Hardware; Mount Axis P8221; Connect The Cables - Axis P8221 Guia De Instalacion

AXIS P8221 Installation Guide

Install the hardware

!
IMPORTANT! - The casing of AXIS P8221 is not approved for outdoor use. The device
may only be installed in indoor environments.

Mount AXIS P8221

AXIS P8221 is supplied with a mounting kit containing screws and plugs for mounting the device to
a concrete wall:
1. Place AXIS P8221 against the wall and mark the location of the two mounting holes (see
page 4) through which the device will be attached.
2. Remove AXIS P8221 and drill the two mounting holes.
3. Insert the wall plugs into the wall, position AXIS P8221 and attached to the wall using the
screws provided.
The supplied protective pads can be used to avoid scratching the surface on which AXIS P8221 is
placed. Punch out the pads and apply them to the underside of the device.

Connect the cables

Please refer to Unit connectors, on page 13, for wiring information.
1. Optionally connect external input/output devices, e.g. alarm devices.
2. Optionally connect external audio equipment.
3. Optionally connect external equipment to the RS-232/485/422 connector.
4. Connect AXIS P8221 to the network using a shielded network cable.
5. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet). If available, this is automatically detected when the network
cable is connected.
• Connect an external power adapter to the power connector block.
6. Check that the indicator LEDs indicate the correct conditions. See the table on page 17 for
further details.
Page 5