Vastar AAVACS01 Manual Del Usuario página 7

ball detent into the extension rod . Then ,insert the socket into the ball detent . Finally
,the installation is complete . The finished product of the installation steps is shown in
the following figure :
+ +
Note:
1. This product is compatible with screwdriver bits which have a 1/4 inch (6.35mm)
hexagonal shaft.
2. To remove the drive bit or the extension bit, you need to pull the knurled collar of
the chuck towards the driver body first.
Step 2: Select the direction of rotation
1. Press the rotation direction switch to the right to
tighten screws. The bit will rotate clockwise.
2. Press the rotation direction switch to the left to
remove screws. The bit will rotate
counter-clockwise.
Step 3: Adjust the torque
Twist the torque adjustment collar to change the torque setting. This product covers
3.5 ~ 10 newton meters (31 ~ 88 inch-pound) torque range, with 7-stage torque
settings.
▪ When the number 1 is aligned with the arrow/white spot on top of the torque
adjustment collar, the torque is the smallest.
▪ When the icon
of the torque adjustment collar, the torque is the largest.
Note:
1. Before actual driving, you could make a pilot hole. Test to find
out the required torque by driving into the targeted material.
2. The the arrow/white spot of the adjustment collar cannot be
locked in a middle position.
is aligned with the arrow/white spot on top
EN-5