Publicidad
Idiomas disponibles
Idiomas disponibles
The manufacturer service is available for all maintenance, repair and assembly work, as well as
for damages.
Unused machines and machine tools should be kept in a dry, closed room.
Keep them free from damaging influences such as damp, frost or large temperature fluctuations
as well as mechanical damage.
Always store the machine in a way that important machine instructions, e. g. on stickers and
signs, are legible.
Dispose worn out/defective machine tools according the local/national regulations. Fully
disassemble machine for the necessary disposal. Separate materials according to local
environmental specifications. Dispose environmentally hazardous greasing, cooling or cleaning
agents in order to avoid environmental contamination.
When working on or with the equipment, it is imperative to observe all legal requirements in
regards to waste-disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging agents, such as
suitable containers!
In case of malfunctions check, if the instructions of this technical documentation are adhered to
and make necessary adjustments.The following table shows possible problems and causes:
a
Machine does not start
b
Machine turns too slowly
c
Gear makes strong noise
d
Other trouble
If necessary, send the machine to the manufacturer.
36
ENVIRONMENTAL REGULATIONS
•
lubricating grease and oil,
•
hydraulic fluid,
•
coolant,
•
solvent containing cleaning agents
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in
TROUBLESHOOTING
Problem
too low operation pressure
STORAGE
DISPOSAL
Cause
not connected to
pneumatic supply
-
-
Remedy
Connecting and opening of
the pneumatic line
increase operation
pressure at the machine to
6 bar
Contact authorized expert
company
Contact authorized expert
company
Publicidad
