Audibax KA Serie Guia Del Usuario

CEILING SPEAKER
KA series
USER GUIDE
The KA range is a series of 2 way ceiling speakers designed with a woofer from 6,5 inches to 8 inches
and 25mm tweeter. The KA series is the perfect choice for the distribution of microphone calls and
background music both for restaurants or commercial stores. The mounting frame is made of high
quality ABS. The grille is made of metal. The KA is available in white.
SAFETY PRECAUTION
• Keep this manual for future reference.
• When cutting the mounting hole for the speaker, make sure there is sufficient clearance behind
the panel (no obstructions like A/C channels, power lines etc).
• Take care of your speaker wires, they should be free of damage. Damaged speaker wires might
result in poor sound quality and can damage amplifiers.
• Only use accessories specified by the manufacturer.
• Make sure the mounting panel can support the speakers weight.
• Use sufficient amount of speakers to avoid dead spots.
• No mains power shall be connected to the loudspeakers, doing so will damage the speaker.
• This apparatus should only be serviced by qualified personnel. If not warranty might be void.
• Use cable of the right gauge, certainly for long runs.
• Use cables with clear color indication and maintain polarity throughout the whole system.
• Avoid loud feedback from microphones, this can damage your speaker.
• Please check the units condition after unpacking. If the outside of the carton box has been
damaged, inform your shipper immediately.
WARRANTY INFO
The warranty for hidden defects can only be considered if they appear within the 24-month warranty
period. The warranty is not valid in case of misuse, wear, power surges, improper packaging or
shipping, improper use or storage and failure to comply with Audibax recommendations. The product
must be returned in the original packaging with proof of purchase made by an authorized distributor
of Audibax
1
MOUNT THE SPEAKER
1
The loudspeaker is easy to install, due to its simple mounting system.
(1) Use the cutout template to mark the mounting hole.
(2) When making the hole in your mounting panel, double check if
there are no cables or any other obstructions behind the mounting
panel. Cutting the mounting panel without this check might result
in damaged infrastructure or power lines. Please make sure that the
2
mounting structure is capable of safely supporting the speaker's
weight.
(3) Remove the speaker grille: turn the mounting clamps (dog-ears)
outwards and push them in the direction of the grille until it pops out.
Remove the grille.
(4) Turn the dog-ears inwards again and tighten the dog-ear screws
slightly to make them stay in the inward position.
3
(5) Connect the speaker wires and insert the speaker in the precut
speaker opening.
(6) Fasten the dog-ear screws carefully until the speaker sits safely in
place. Do not overtighten the dog-ear screws!
(7) Carefully push the grille back in place.
4 5
Model
Characteristics KA06
Outside diameter 240mm
Depth 83mm
Loudspeaker system 2 ways
Woofer size 6,5"
Tweeter size 25mm
Impedance 8 ohmios
Power 60W
SPL 88
Frequency 80HZ-20KHZ
Material ABS
Grille material Metal
100W Line No
6 7
Model
KA08
280mm
92mm
2 ways
8"
25mm
8 ohmios
70W
88
50HZ-20KHZ
ABS
Metal
No
2