Vonyx VX210 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWER SUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
OPERATION PANEL
1. MICROPHONE INPUT
Balanced XLR input for connecting a dynamic microphone.
2. LINE INPUT
Unbalanced 6.3mm line jack input for connecting a guitar, synthesizer,
CD-player or other line-level devices.
3. BASS
Rotate to adjust the low (bass) tones of the corresponding channel.
4. TREBLE
Rotate to adjust the high (treble) tones of the corresponding channel.
5. LEVEL
Rotate to adjust the volume level of the corresponding channel.
6. FX
Rotate to adjust the fx effect level of the corresponding channel.
7. LINE INPUT
RCA line input.
8. DELAY LEVEL
Adjust the mix level of the effect sound.
9. DELAY TIME
Adjust the time interval of the delays.
10. DELAY REPEAT
Adjust the rate of the delays.
11. TREBLE
Rotate to adjust the high (treble) tones of all channels.
12. MID
Rotate to adjust the mid tones of all channels.
13. BASS
Rotate to adjust the low (bass) tones of all channels.
14. AUX INPUT
Unbalanced 6.3mm auxiliary jack input.
15. AUX OUTPUT
Unbalanced 6.3mm auxiliary jack output.
16. AUX INPUT
RCA auxiliary input. Signal is sent to the speaker output directly.
17. REC OUTPUT
RCA REC output to connect with a tape deck, soundcard, or portable recorder.
The signal mirrors the speaker output.
18. MP3 BUTTON CLUSTER
Stop – press to stop play.
Play/pause – press to (re)start or pause playback.
Previous – press to change to previous track. Press and hold to decrease track
volume.
Next – press to change to next track. Press and hold to increase track volume.
Mode – press to switch modes.
19. USB
20. SD
3