Aike AK1903 Guia Del Usuario página 2

User Guide
Magnetic
top cover
Twist cap
Twist cap
Filling port
Shell
Power button
indicator triangle
Battery holder
Installation height notes
≥35cm
(13.78 inches）
Battery replacement reminder
Flashing of the indicator light is a sign to replace batteries. Make sure to replace all four AA
alkaline batteries for every battery replacement.
EN
Bottom diagram
Dispensing nozzle
Power button
Anti-theft Power button
screw hole
Level meter
Self-adhesive
mounting plate
Recommended dispenser
installation height in the
shower room: 1.1-1.3m
(42.31-51.18 inches)
1
How to install your dispenser
If the wall is smooth and flat (such as tiles, glass, wood, etc.), you can mount the dispenser using
the self-adhesive mounting plate. Follow the instructions below:
①
Wipe the wall clean and keep it dry.
③
When the bubble in the level meter is at the
center, it indicates that the mounting plate
is in a horizontal position.
Use the included level meter to calibrate the
level of the mounting plate, then attach the
mounting plate to the wall and press to elim-
inate any air.
⑤
Install the anti-theft
screw to complete
the installation.
Anti-theft screw
EN
②
Remove the protective film.
④
Upper slot
Upper clip
Lower slot
Lower clip
Align the hooks of the mounting plate with
the slots on the back of the dispenser and
attach the dispenser to the mounting plate
by sliding it down until both clips snap into
place.
⑥
Note:
If the wall does not meet the
conditions mentioned above,
please use the screws included
in the package to install your
dispenser.
2