Sharp SJ-LD125E0XS-EU Manual De Uso página 12

after putting fresh food into the appliance, it
is normal for the indication "OK" not to
appear in the temperature setting indicator.
If there is an abnormal build up of ice
crystals of ice crystals (bottom wall of the
appliance) on the refrigerator compartment,
evaporator (overloaded appliance, high
room temperature, frequent door openings),
put the temperature setting device on a
lower position until compressor off periods
are obtained again.
Store food in the coldest area of the
refrigerator.
Your foods will be better stored
if you put them in the most
appropriate cooling area. The
coldest area is just above the
crisper.
The following symbol indicates the coldest
area of your refrigerator.
To be sure to have a low temperature in this
area, make sure the
shelf is located at
the level of this
symbol, as shown in
the illustration.
The upper limit of
the coldest area
is indicated by the
lower side of the
sticker (head of the arrow). The coldest
area upper shelf must be at the same level
with the arrow head. The coldest area is
below this level.
As these shelves are removable, make
sure they are always at the same level with
these zone limits described on the stickers,
in order to guarantee temperatures in this
area.
3.5 Accessories
Visual and text descriptions in the
accessories section may vary according
to the model of your appliance.
3.5.1 The Fresh Dial (In some models)
(The images are representative)
(The images are representative)
If the crisper is full, the fresh dial located
in front of the crisper should be opened.
This allows the air in the crisper and the
humidity rate to be controlled, to increase
the life of food within.
The dial, located behind the shelf, must be
opened if any condensation is seen on the
glass shelf.
EN - 11
or