Publicidad
Idiomas disponibles
Idiomas disponibles
!
DO NOT use any load bearing contact points other
than those described in the instructions and marked in
the child restraint.
IF IN DOUBT ABOUT THESE POINTS OR ANY
QUESTIONS RELATED TO INSTALLATION, PLEASE
CONTACT HARMONY JUVENILE PRODUCTS.
DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see "Vehicle
seating positions").
2. Place child on the booster seat with child's back flat
against the vehicle seat.
3. Thread both sides of the lap belt under BOTH
armrests. Thread the lower end of the shoulder belt
under the armrest on the buckle side ❶. ENSURE
that the belt is snug
across
hips. It is important
to ensure that the
lap strap is worn low
down, so that the pelvis is firmly
engaged, just touching their thighs
and is NOT across their stomach.
19
INSTALLATION
WARNING!
!
the
child's
❶
Publicidad
