Publicidad
Idiomas disponibles
Idiomas disponibles
The cup holder can be found under the
booster seat base. To remove for use,
twist cup holder while pulling to release.
TO INSTALL:
1. Slide cup holder into place over cup
holder clip ❶❷ on either side until
locked in place.
TO REMOVE:
1. Pull cup holder up and outward.
This restraint is NOT CERTIFIED for aircraft use. Aircraft
seats are not equipped with 3-point lap-and-shoulder
belts which are required for use with this booster seat.
INSTRUCTION MANUAL STORAGE
We recommend that you store your
instruction manual inside the mesh
pocket located under the fabric on the
side of the booster seat. Tuck mesh
pocket back under fabric whenever
the seat is in use.
REMOVING/INSTALLING FABRIC SEAT COVER
TO REMOVE SEAT COVER:
Gently grasp the back of the fabric seat cover and slide
the cover off the plastic shell from the back towards the
front of the booster seat.
TO INSTALL SEAT COVER:
We recommend first sliding the fabric cover's armrests
midway onto the armrests of the plastic shell. Then,
while holding the fabric in place with one hand, slide
USING CUP HOLDER
AIRCRAFT INSTALLATION
❶
❷
22
Publicidad
