LaserLiner MultiFinder Plus Manual Del Usuario página 13

Safety instructions
Dealing with electromagnetic radiation
– The measuring device complies with electromagnetic
compatibility regulations and limit values in accordance
with EMC-Directive 2014/30/EU.
– Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards
or interference or be subject to hazards or interference.
– The measuring accuracy may be affected when working close
to high voltages or high electromagnetic alternating fields.
– Precautions: Do not use any other MultiFinder Plus within
a distance of 5 m. Do not use any electronic transmitters
or electric motors in the vicinity.
1
2
3
4
5
1
Insert battery
Open the battery compartmenton the
housing's rear side and insert a 9 V battery.
Correct polarity must be observed.
2 Operation
Switch on: Briefly press the On/Off button (4).
Switch off: Keep the On/Off button (4) pressed for 4 seconds.
AutoShutOff: The device will automatically switch itself off
about 2 minutes after the last measurement.
MultiFinder Plus
1 Maximum display
2 VTN display
3 Live wire warning
4 ON / OFF
Switching measuring mode
5 Manual calibration (CAL)
13
EN