Bimar PASSION LINE SHR181-1 Folleto De Instrucciones página 8

Fax +39 030 9904733

I
f the blades become jammed, switch off the appliance (by releasing the button) and remove the plug
from the mains before removing the ingredients that have caused the blades to jam.
D
o not use the container to store food. It must be emptied before and after use.
N
ever switch off the appliance by turning the cover or the container. Always switch it off by releasing
the button and removing the plug from the mains.
M
ake sure that the motor body does not come into contact with water or other liquids and do not put
them in the dishwasher. If by chance they get wet or go under water, pull out the mains plug
immediately, dry carefully and check that no liquid has entered inside; if in doubt, contact
professionally qualified personnel.
D
o not touch the appliance with wet hands or feet.
T
his appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
A
ppliances can be used by persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and if they understand the hazards involved.
C
hildren shall not play with the appliance.
W
arning: when using electrical appliances, the basic safety precautions must always be observed to
avoid risks of fire, electric shocks and physical injury.
D
o not move the appliance while it is running.
D
o not expose the appliance to the weather (sun, rain, etc.).
N
ever move the appliance by pulling the cord.
T
he user must not leave the appliance unattended while it is connected to the supply.
R
emove the plug from the mains if the appliance is in use, even if not being used for a short while.
I
n order to prevent the risk of electric shock, do not immerse the plug, the cable and the appliance itself
in water or any other liquid.
D
o not pull on the power cord or the appliance to unplug the appliance from the electric socket.
I
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center or a
qualified professional, to avoid any risks.
INSTALLATION
After removing the packing materials, check the integrity of the appliance; if you are unsure, do not use
it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails,
etc.) must be kept out the reach of children because they are potential sources of danger; but dispose of
them in accordance with current law.
Before connecting the appliance, check that the voltage shown on the data plate matches that of your
electricity and that the electric plug is grounded. In the event of incompatibility between the electric
outlet and the plug of the appliance, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the appliance. In general, the use of adapters or extension cords
is not recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the appliance.
Before each use, verify that the appliance is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
Position the utensil far from other sources of heat, objects or anything else that could come into contact
with the hot parts. Check that the support surface is stable and flat to prevent the utensil from tipping
over.
It is recommended to keep the unit away from the edge of work surface and out of reach of children.
Position the utensil far from liquid containers (washbasins for example, etc.), to protect against water
splashes or from falling into the same.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in order
to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language integrity.
8/16
Assembly page 8/28