Descargar Imprimir esta página

Jackery Explorer 600 Plus Manual Del Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

7
AC Wall Charging Indicator
10
Battery Power Indicator
13
Fault Code
16
Energy Saving Mode
19
Remaining Discharge Time
UPS:
Once you have connected the mains and the AC input port of the product via the AC charging cable,
you can use the AC output port of the product to power your unit (at this point the AC power comes
from the mains, not the battery of the product). In the event of a sudden loss of mains power, the
product can automatically switch to battery mode within 20ms. This product does not support 0ms
switching. Do not connect to equipment with high uninterruptible power requirements such as data
servers and workstations. Please test several times to confirm compatibility before use and it is
recommended to connect to only one device. Do not use more than one unit at a time to avoid
triggering the overload protection. Failure to follow these instructions may result in equipment failure or
loss of data for which we cannot be held responsible.
Battery Power Indicator
When the product is being charged, the orange circle around the battery percentage will light
up in sequence. When charging other devices, the orange circle will stay on.
Low Battery Indicator
When the battery is less than 20%, the Low Battery Indicator will stay on. When less than 5%,
the Low Battery Indicator will flash. When it is being charged, this Indicator will be o .
Energy Saving Mode
To avoid forgetting to turn off the output which results in battery consumption, the product
turns the Energy Saving Mode on by default. This occurs when no device is connected or the
connected device is less than or equal to a certain value (Refer to the table below for more
details), the device will automatically turn off all outputs after 12 hours.
Output
AC Output
USB Output
Car Output
To turn o the Energy Saving Mode
Long press the AC Button and Main Power Button until the Energy Saving Mode icon
disappears. In Non-Energy Saving Mode, please remember to turn o the products to avoid
battery consumption.
To turn on the Energy Saving Mode
Long press the AC Button and Main Power Button until the Energy Saving Mode icon lights up
on the screen.
8
Car Charging Indicator
11
Low Battery Indicator
14
High Temperature Warning
17
AC Power Indicator
Output Power
Defaults
≤25W
All outputs turned o automatically after 12 hours
≤2W
≤2W
9
Solar Charging Indicator
12
Remaining Battery Percentage
15
Low Temperature Warning
18
Output Power
US
03

Publicidad

loading

Este manual también es adecuado para:

Je-600c