Publicidad
ASSEMBLY / ASSEMBLÉE / VERSAMMLUNG / MONTAJE / MONTAGGIO
B
B
J
F
F
1. 1. To assemble the support section of the unit, take both Legs (B) and both Supports (C).
Push the Cross Dowels (G) and the Wooden Dowels (J) into the pre-drilled holes on the Supports (C),
ensure the holes of (G) are facing outwards to receive the Bolts (F).
Using a crosshead screwdriver to hold eachCross Dowel (G) in place, tighten the adjoining Bolt (F).
A4L | 01
B
J
C
F
G
C
F
D
E
I
2. 2. To attach the Cabinet (A) to the assembled support, align the holes on (A) with the upper holes on the Legs (B).
Mount the Holder (D) - this can be done on either side - ensuring that it sits between the Leg (B) and the Cabinet (A).
IMPORTANT: Mounting the Holder incorrectly this will cause it to tip when the Cabinet angle is adjusted.
To secure into place, insert a Bolt (E) through the side of each Leg (B) - and Holder (D) if applicable - then through a
Washer (I) and into the Cabinet (A). Tighten to secure.
I
E
Publicidad
