Publicidad
Idiomas disponibles
Idiomas disponibles
Trimming
3 inches (8 cm
above ground
SCALPING
- The scalping technique
removes
unwanted
vegetation
down
to the ground. Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low the tip of the line to strike the
ground around trees, posts, monu-
ments, etc= This technique
increases
line wear.
Scalping
MOWING
- Your trimmer is ideal for
mowing in places conventional
lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing
the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING
- The fanning action of the
rotating line can be used to blow away
loose debris from an area. Keep the line
parallel to and above the area surface
and swing the tool from side to side.
'_
Sweeping
_A
T
MAINTENANCE
SCHEDULE
WARNING:
Disconnect
the spark plug before performing
maintenance
except for carburetor
adjustments.
CARE & MAINTENANCE
TASK
Check for loose fasteners and parts
Check for damaged
or worn parts
Inspect and clean unit and labels
Clean air filter
Inspect muffler and spark arresting
screen
Replace spark plug
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Every 50 hours of operation
Yearly
GENERAL
RECOMMEN
DATIONS
The warranty on this unit does not
cover items that have been subjected
to operator
abuse or negligence.
To
receive full value from the warranty,
the operator
must maintain
unit as
instructed
in this manual. Various ad-
justments
will need to be made peri-
odically to properly maintain
your unit.
CHECK
FOR LOOSE
FASTENERS
AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
• Assist Handle Screw
• Debris Shield
14
Publicidad
