__291789_Munddusche_B8.book Seite 20 Montag, 9. Oktober 2017 5:02 17
place a non-slip mat under the battery
charger.
Never place the device on hot surfaces
(e.g. hot plates) or near heat sources or
open fire.
Do not use any astringent or abrasive
cleaning agents.
CAUTION
In the first few days of use of a dental
water jet, some users may experience
slight gum bleeding. If the bleeding lasts
longer than 14 days, a dentist should
be consulted.
If you suffer from severe periodontitis,
have injuries or ulcers in the oral muco-
sa or have had dental surgery during
the last two months, please consult a
dentist before using the dental water
jet.
4. Items supplied
1
dental water jet 12
2
nozzle attachments 2
1
battery charger 15
2
rawlplugs, diameter 5 mm
screws 3 x 25 mm
1
copy of the user instructions
• Remove all packing material.
• Check whether all accessories are pres-
ent and undamaged.
20 GB
5. Battery charger
The battery charger 15 can either be
placed on a surface or attached to a wall.
•
Insert the mains power cable 17
through one of the 3 recesses in the
housing of the battery charger 15.
Wall mounting
NOTES:
•
Please note the rawlplug size when se-
lecting the drill.
•
If your wall material requires it, replace
the fixing material supplied with a suita-
ble one.
•
Figure A: mount the battery charg-
er 15 to a wall according to the
holes 16 on the back as shown in the il-
lustration.
6. Charging the battery
NOTES:
•
Fully charge the battery before using it
for the first time. This takes 14 - 16 hours.
•
Place the dental water jet 12 on the
peg 14 of the battery charger 15 after
use. This ensures that the dental water
jet 12 always works at full power. The
battery is not damaged by regular
charging.
1. Plug the mains plug 17 of the battery
charger 15 into a suitable wall socket.
The wall socket must continue to be easi-
ly accessible after the device is plugged
in.
2. Place the switched-off dental water
jet 12 on the peg 14 of the battery
charger 15.
The charging indicator light charge 11
is lit in red throughout the entire charg-
ing process. When the optimal charging