BSS -Case Economic Instrucciones De Uso página 23

Installing the ATEM Mini / Extreme
Safety note: Before doing any work on the BSS case, pull the mains plug out of the socket! Do
not touch the built-in electronic components when the installation slot is open. Even when the
mains plug is unplugged, these can remain live for a long time and cause an electric shock.
Risk of tipping: When installing the ATEM Mini Extreme yourself, there is an acute risk of tip-
ping over after opening the lid in its end position. Only after installing the ATEM Mini does the case
reach the balanced center of gravity.
Therefore, when opening the cover,
hold the case in a horizontal position with
the help of a second person until the ATEM
Mini Extreme has been installed.
Plug in the cables
Note: Never pull the cables with force, as this
could damage them.
(Image 11) Danger of tipping over if
ATEM Extreme is not installed
(Image 12) Plug the cable into the
ATEM Mini
Note: Work carefully and never force the
ATEM Mini into the recess! If you feel too much back pressure or if the cover plate deforms un-
der the pressure of the cables, carefully remove the ATEM Mini / Extreme and sort the cables
again until the ATEM Mini / Extreme can be inserted into the recess without too much counter
pressure. You may have to repeat this process several times until the ATEM finds its pressure-
free seat.
With the ATEM Extreme, the counter-pressure when used is correspondingly higher due to the
almost double number of cables. However, please also note the above-mentioned conditions
for assembly.
Start up
Turning on/off
(Image 13) Swing in the ATEM Mini
(Image 14) Screw ATEM Mini with C-clamps
DE
EN
FR
IT
ES