Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4. Attach L-bracket (DD) to assembly, using1/4 in. x
12 mm bolt (AA). Tighten with hex wrench (CC).
Hardware Used
AA
1/4 in. x 12 mm Bolt
CC
Hex wrench
DD
L-bracket
5. Attach top panel (A), shelves (I) and bottom panel (J) to
assembly. Secure in place with M4 x 35 mm screws (BB).
Hardware Used
BB
M4 x 35 mm Screw
4
CC
AA
x 16
x 1
H
D
F
x 4
E
5
I
J
x 40
BB
7
ASSEMBLY INSTRUCTIONS
6a. Adjust floor levelers to level the unit against the wall
where desired.
6b. Using top frame (B) as a template, mark one mounting
holes location on the wall. Drill one pilot holes into the
DD
wall where previously marked. Make sure that the
drilled holes can fit for the wall anchors (sold separately)
properly. Press the anchors into the holes and gently tap
with a hammer until flush in the holes. If the mounting
B
hole coincides with a wooden stud, there is no need wall
anchor.
6c. Align top frame (B) and back crossers (HH) over the
drywall anchors (II) and secure with M5 x 65 mm
screw (EE). Tighten securely with phillips screwdriver.
C
Hardware Used
M5 x 65 mm
EE
Screw
A
Back Crosser
HH
II
Drywall Anchor
7. If you buy more than one unit, you can collect more style.
8. Secure units together by attaching the metal plates (GG)
with the 1/4 in. x 12 mm bolts (AA) into the holes. Tighten
with hex wrench (CC).
NOTE: Must install step 6 for all secured units.
Hardware Used
AA
1/4 in. x 12 mm Bolt
CC
Hex wrench
GG
Metal plate
6
II
HH
B
EE
x 1
7
x 1
x 1
8
x 6
x 1
AA
x 2
8
Wall
GG
CC
Publicidad
