Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
3. Mark the hole location of the Bottom Mount Wall
Clips (DD).
Hardware Used
DD
Bottom Mount Wall Clip
Use a level to ensure the vertical
PRO TIP
standard is straight.
4. Move the Vertical Standard (A) to the side to
reveal the marks made in the previous step. Using
5/16" drill bit to pre-drill holes into drywall. Use a
1/8" drill bit if this is in a stud. Do not drill through
the metal brackets.
If you are unsure if a stud is located
PRO TIP
behind markings, use 1/8" drill bit to
drill all holes. If no stud is present,
then use 5/16" drill bit to make holes
larger for drywall anchors.
3
x 1
4
7
DD
Publicidad
