NICREW RGB+W 24-7 Manual De Instrucciones página 7

English
Programming Using the Controller Keypad
Programming
• Press bu�on to turn on the light.
• Press and hold the
�me se�ng.
• Press HOUR+ and MINUTE- to adjust the current hours and minutes.
• Press to program Ligh�ng Phase 1.
• Con�nue pressing
• A�er finish se�ng P1 to P5, press
• Press HOUR+ or MINUTE- to choose the ramp �me.
• Press to save and exit 24/7 se�ng.
NOTE:
• When the LCD displays the start �me of ligh�ng phase, press
on the controller to disable the corresponding ligh�ng phase.
Press again to resume programming.
• If no bu�ons are pressed within 5 seconds, the �mer will exit setup
and return to the home screen.
• If, at any �me, you wish to turn your lights on, simply press the
bu�on. Long press the
bu�on to resume the 24/7 mode.
Reset to Factory Se�ngs
Press and
for 3 seconds to reset the controller. It will reset the unit to factory
default se�ngs.
Used for se�ng hours and increase intensity.
Used for se�ng minutes and decrease intensity.
Press bu�on to turn on the light.
• Press
preset color se�ngs.
• Press and hold the
off the light.
Used for se�ng 24/7.
bu�on for 3 seconds to enter the current
to program P2 to P5.
on the controller simultaneously, hold them down
again to cycle through the light's different
bu�on for 3 seconds to turn
again to set ramp �me.
bu�on to turn them off. Press the