Publicidad
Idiomas disponibles
Idiomas disponibles
global_main.book.book Page 14 Friday, April 5, 2024 5:07 PM
INSTALLATION
14
• If the drain hose is too long, do not force the
drain hose further into the drain outlet. This will
cause abnormal noise.
NOTE
• The drain hose must not be placed higher than
120 cm above the floor. Water in the appliance
may not drain or may drain slowly.
Levelling the Appliance
Checking the Level
Levelling the appliance prevents unnecessary
noise and vibration. Check whether the appliance is
perfectly level after installation.
• If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
Adjusting and Levelling the
Feet
When the appliance is not perfectly level, turn the
adjustable feet until the appliance no longer
wobbles.
• Turn the adjustable feet clockwise to raise or
turn the adjustable feet counterclockwise to
lower the appliance.
NOTE
• Do not insert pieces of wood etc. under the feet.
• Timber or suspended type flooring will
contribute to excessive vibration and unbalance.
Reinforcing or bracing the timber floor may be
need to stop or reduce excessive noise and
vibration.
• Do not install the appliance on any elevated
surface or platform, as it may become unstable
and cause serious injury and damage.
• If the appliance is installed on a uneven, weak or
tilted floor causing excessive vibration, spin
failure or unbalance error can occur. It must be
placed on a firm and level floor to prevent spin
failure.
Assembling the Anti-Rat Cover
You can insert the anti-rat cover according to the
type to protect the appliance from the rat.
Folding Type
1
Lay the appliance backwards.
CAUTION
• Be careful your feet or hands when you lay or
raise the appliance.
2
Remove the sponge attached on the base.
3
Insert the 7 screws
into the holes to
a
assemble the anti-rat cover to the appliance.
Publicidad
