Publicidad
Idiomas disponibles
Idiomas disponibles
To adapt the wash programme to your individual requirements, you can, for example, change the tem-
perature and spin speed settings or switch on additional functions (see "16.6. Setting additional func-
tions" on page 60).
Put detergent in the detergent compartment (1).
Press the Start/Pause button (12) to start the wash cycle.
As soon as the wash programme is running, the
16.3. Interrupting a programme
Press the Start/Pause button (12) to interrupt the wash programme.
In PAUSE mode, the
If you want to add laundry after the programme has started it should be done in the first minutes of the
wash cycle to achieve a good wash result. If the water level in the drum is still low, the washing machine
door (4) can be opened after a short time and the laundry can be added.
Then close the washing machine door (4).
Press the Start/Pause button (12) again to continue the wash programme.
The PAUSE function can be used to soak the laundry. Soaking can improve the washing result
for heavily soiled laundry.
Wait about 10 minutes after starting the selected programme and then press the Start/
Pause button (12).
When the desired soaking time has elapsed, press the Start/Pause button (12) again to
continue the wash programme.
16.4. End of wash programme
The end of the wash programme is indicated by
Switch off the washing machine by setting the programme selector (2) to the Aus (off) position.
Wait until the washing machine door (4) has been unlocked (see also "15.10. Door lock" on page
58). Then open the washing machine door (4) and remove the laundry promptly to avoid creasing.
Pull the mains plug (10) out of the mains socket.
Turn off the stopcock.
Leave the washing machine door (4) open and pull out the detergent compartment (1) slightly to allow
the inside of the appliance to dry to avoid mould or unpleasant odours.
If no further buttons are pressed, the washing machine switches to standby mode 15 minutes after the end
of the programme.
16.5. Cancelling a programme/draining water
To cancel a programme, turn the programme selector (2) to the Aus (off) position.
To drain the remaining water, set the programme selector (2) to any programme. The water is drained
and the programme is cancelled. In the operating display (1 1) the function symbol for the selected pro-
gramme flashes (see table in section "1 1. Possible displays" on page 52) as well as the
start/pause.
Then set the new wash programme and add detergent to the detergent compartment (1) again if neces-
sary.
Press the Start/Pause button (12) to start the wash cycle.
If you do not want to start a new wash cycle after the water has been drained, do not select a new wash
programme, instead turn the programme selector (2) to the Aus (off) position to switch off the appli-
ance.
symbol for the wash cycle and the
End
and
symbols light up continuously.
symbol for start/pause flash.
in the digital display (17).
symbol for
English - 59
Publicidad
