Shop-Vac 87MT Serie Manual Del Usuario página 6

TOP HANDLE
If the top handle is not installed on your unit, align holes in handle and holes in motor
cover and secure with screws provided.
CASTER SYSTEM
Follow the instructions for the caster system that came with your vacuum.
METAL TANK WITH PLASTIC DOLLY AND FOUR CASTERS
You will find four casters with your wet/dry vacuum. Assemble as follows:
1. With the cord disconnected from the receptacle and tank cover removed, turn tank upside down so that
bottom is facing up.
2. Insert casters into bottom of dolly by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place.
3. Return tank to upright position.
CASTER DOLLY/TOOL HOLDER ASSEMBLY
You will find four casters, one tool holder and two screws with your wet/dry vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so that bottom
is facing up.
2. If the casters are not already installed in dolly, insert casters into bottom of dolly by
placing stem of caster into holes provided. Apply pressure and twisting motion until
casters snap into place.
3. Take tool holder and place in slots on back of dolly. Secure with
screws provided.
4. Return tank to upright position.
METAL TANK WITH PLASTIC DOLLY AND REAR WHEELS
You will find two casters, two large rear wheels, one axle, tool rack, four screws, two metal washers, and
two hair pin clips. If your vacuum is 16 U.S. gallons (60.5 litres) or larger you will also find two screws, two
metal flat washers and two square nuts with your wet/dry vacuum. Assemble as follows:
1. Make sure the cord is disconnected from the receptacle then remove the tank cover.
2. If your unit is 4 U.S. gallon (15.1 liter) to 14 U.S. gallon (53 liter), assemble as follows:
a. Turn tank upside down so the bottom is facing up.
b. Continue on to step 4 below.
3. If your unit is 16 U.S. gallon (60.5 liter) or above, assemble as follows:
a. With the tank upright and back facing you, insert square nut into one of the two
slots located in back of dolly.
b. Place metal flat washer over stem of screw.
ASSEMBLY
PAGE 5