Publicidad
Idiomas disponibles
Idiomas disponibles
CLOSE-TO-CEILING MOUNTING
1. Carefully unhook the fan from the mounting
plate and align the locking slots of the ceiling
canopy with the two screws in the mounting
plate. Push up to engage the slots and turn
clockwise to lock in place. Immediately
tighten the two mounting screws firmly.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE
ENGAGED AND FIRMLY TIGHTENED.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by
aligning the ring's slots with the screws
in the canopy. Rotate the ring counter-
clockwise to lock in place.
4. You may now proceed to attaching the fan
blades.
8.
Attaching the
Fan Blades
1. Attach the blade to blade bracket using the
screws as shown in figure 13. Please note
that the rubber washers are pre-attached
to the blade bracket. Start a screw into
the bracket. Repeat for the two remaining
screws.
2. Tighten each screw securely.
3. Fasten the blade/ blade bracket assembly to
the motor by inserting the alignment post
into the slot on the bottom of the motor and
tightening the blade bracket screws. Please
note that the blade bracket screws are pre-
installed into the blade bracket (Figure 14).
4. Repeat steps 1, 2 & 3 for the remaining
blades.
Screws
Blade Bracket
Rubber Washers
Alignment Post
Screws
Blade/Blade Bracket
Assembly
Blade
Figure 13
Slot
Figure 14
Publicidad
