Publicidad
Idiomas disponibles
Idiomas disponibles
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blades are securely mounted
to the blade brackets.
2. Make sure the blade brackets are not bent
or out of position and ensure the blade tips
are even. Use the enclosed Blade Balancing
Kit if the blade wobble is still noticeable by
carefully following the instructions included
in the kit.
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE BRACKETS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
Attaching the Light
Kit/Glass Bowl
CAUTION - To reduce the risk of electric
shock, disconnect the electrical supply circuit
to the fan before installing the light fitter.
1. Loosen the three serrated head screws
on the switch cup cover of the light kit
(Figure 15).
2. Connect the wires from the light kit to the
wires from the switch cup of the fan motor
assembly by connecting the molded adaptor
plugs together (blue to black, white to
white). Carefully tuck all wires and splices
into the switch cup.
3. Align the three serrated head screws on the
switch cup cover of the light kit with the
three key slots in the switch cup. Make sure
the notch in the switch cup cover of the light
kit clears the reversing switch in the switch
cup. Position the light kit on the switch cup
and turn it clockwise until it locks. Tighten
the three serrated head screws that were
loosened in step 1 to secure the light kit
(Figure 15).
4. Remove the bottom cover and the finial
from the light kit (Figure 16).
5. With power off, install the three fluorescent
bulbs (Max. 14W, included) by screwing
into the light bulb sockets.
6. Position the glass bowl and the bottom
cover over the threaded nipple and pass the
fan switch chain through the offset hole in
the bottom cover.
7. Re-install the finial and finger tighten the
finial.
CAUTION - Be sure that the fan switch chain
does not make contact with the light bulbs.
Key Slot
Holes
Blue
White
Black
Serrated
Head
Screw(3)
Light Kit
Switch Cup
Bulbs
Threaded
(provided)
Nipple
Finial
Reverse
Switch
Switch Cup
Notch
Switch Cup
Cover
Figure 15
Glass Bowl
Bottom Cover
Figure 16
9.
Publicidad
