Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing the appliance before use
• This accessory can be fitted to the wall
with screws and wall plugs or silicon,
plaster, etc.
Fig. 16
If do not wish or need to use the air-
conditioning, remove the hose from the
hole and close the covers on the
accessory to close the hole in the wall.
Separating the flexible hose from
the indoor unit
The hose must be dismantled from the
indoor unit in order to fit it through the wall
(this is only possible on models with
disconnectable hose). To do this, proceed
as follows:
• Disconnect the appliance from the mains
electricity supply.
• Remove cover F, Fig. 1, from the indoor
unit. The flexible hose join is now visible,
Fig. 18.
• To extract the electrical connection,
remove the screw and the cover which
conceals it, Fig. 19A. Press the tabs on
the side of the connector carefully and
remove it from its housing, Fig. 19B.
All manuals and user guides at all-guides.com
Fig. 17
Fig. 18
45
A
• Dismantle the condensed water drainage
tube by turning it a 1/4 turn anti-
clockwise and remove it, Fig. 20. Be
particularly careful when removing this
tube as some of the water it contains
may splash.
• Keep tab A, which secures the position
of the lever, pressed in. Pull it upwards
(be careful with the spring of the lever),
making sure that it remains at its
maximum height, Fig. 21.
• Pull the hose off its housing guides. Fig.
22.
B
Fig. 19
1
2
Fig. 20
Fig. 21
Publicidad
