Urrea CN1108 Manual De Usuario Y Garantía página 23

2. Attach the leveling feet (C) to the base by
screwing the threaded portion of the foot into the
threaded holes in the base.
3. Attach the swiveling
foot pedal (Fig.2-D) to
the base using two M8 x
20mm Carriage bolts and
two M8 hex nuts.
4. Turn the base back over so that the wheels
are on the ground and adjust the leveling feet
until the unit does not rock or wobble.
MOUNTING JOINTER TO BASE
IMPORTANT: The machine is heavy, two peo-
ple are required to unpack and lift. Use a safety
strap to avoid tip over when lifting machine.
1. Be sure the pulley on the motor is in line
with the cutout in the top of the stand so the
drive belt can pass through.
2. Using a helper, lift the jointer onto the stand
(Fig.3).
Fig.3
3. Align the 3 bolt holes located in the base of
the jointer with the 3 holes in the stand.
4. Use the special
mounting studs and
M10 lock washers, 2
of which are shown
in fig. 4, to secure the
jointer to the stand.
Tighten securely.
NOTE: The third mounting stud is accessible by
reaching up through the hole in the top of the
dust chute.
ASSEMBLING BELT AND ALIGNING PULLEYS
1. Remove the cut-
terhead pulley guard
(Fig.5-A) by loosening
the screw (B).
2. Place the V-belts
onto the cutterhead
pulley (Fig.6-C).
Fig.2
D
Fig.4
Mounting
studs
A
B
Fig.5
E N G L I S H •
3. Loosen the motor
mounting bolts and
raise the motor up un-
til the belt fits around
the motor pulley (D).
4. Using a straight
edge, check that both
pulleys are aligned in
the same plane. If the
pulleys are not inline,
reposition the motor
until the pulleys are
aligned.
5. Tighten the motor mounting bolts. Check
the alignment of the pulleys once more to as-
sure nothing has moved.
NOTICE: If alignment cannot be met by moving
the motor in or out, loosen the motor pulley
set screws and move pulley in or out on the
shaft until proper alignment is achieved.
WARNING: The outside edge of the pulley
must never be extended past the end of the
motor shaft in any circumstance.
ADJUSTING BELT TENSION
1. Correct belt tension is obtained when there
is approximately 1" deflection at the center
span of the belt using light finger pressure.
2. If an adjustment is required, the motor can
be raised or lowered to obtain the correct belt
tension.
3. Tighten motor mounting hardware after
tension is applied, making sure alignment of
the pulleys is not disturbed.
4. Replace the cutterhead pulley guard.
ASSEMBLING FENCE CARRIAGE ASSEMBLY
The fence carriage assembly is already installed
on the jointer at the factory. You only need
to take a few steps for the fence to be fully
operational.
WARNING: Make certain that the machine is
disconnected from the power source.
1. Insert the fence
knob(Fig.7-A) through
the hole, only this
time make sure that
the handle shaft goes
Through the top of
the fence assembly.
U se r's m a nua l
C
D
Fig.6
A
Fig.7
23