Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 5 : Place external sides + Back weight bearing. Position the external sides on the refractory
floor. Fasten the back weight bearing to the ears with the ¼" screws with nuts and washers. Center and
adjust the assembly.
Back weight bearing
FRONTAL VIEW
STEP 6: Place the refractory back + internal
back
in
the support
adjusting them with the upper screws of the back weight bearing. On the side where the
stove is going to be positioned, place a clamp to hold the internal refractory side.
Refractory back
STEP 7: Place the ratchet, handle, bushings and hardware chains (+ iron separator plate if applicable)
Position the ratchet in the side housings, fit the handle with the bushings and chains + on the fire side place
the separator plate secured with the ¼" conical head screw (if applicable). NOTE: only these pieces are
placed to later be able to seal the concrete pieces without dirtying the rest of the hardware. The handle
must be in a horizontal position for the grill lifting mechanism locking system to function correctly. (FIG.1)
Ratchet
Iron
separator
plate
(if
applicable)
N02
position
against
FRONTAL VIEW
FRONTAL VIEW
External side
Refractory floor
refractory sides. Place the refractory
the
back
weight
Internal
refractory
side
Refractory
back
Handle
Bushings
IMPORTANT: The grill is prepared to place the
and chains
handle on either side. If it is a fitting with a stove,
the log holder always goes on the opposite side of
the handle command.
Back weight bearing
REAR VIEW
bearing
and
place
Clamps for
internal side.
(stove side)
Internal
refractory side
REAR VIEW
(FIG.1)
Correct handle
position
HANDLE SIDE VIEW
www.parrillasbinelli.com
External side
Refractory floor
Ring
the
clamps,
/parrillasbinelli
Publicidad
