Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
f.
Insert the saw blade (G) into the blade clamp as far as it will go and release the sleeve to
lock the blade in position.
g. Check that the blade is securely attached.
Removing the Saw Blade
WARNING:
• The saw blade may be very hot after use. Allow the blade to cool down or wear gloves when
removing a saw blade.
a. Rotate the sleeve of the blade clamp (E) counterclockwise to open the clamp.
b. Remove the saw blade (G) from the blade clamp.
WARNING:
• The saw blade may be very hot after use. Allow the blade to cool down or wear gloves when
removing a saw blade.
• Use only a standard reciprocating saw blade. Never try to use T- or U-shaped jig saw
blades. Failure to heed this warning could cause loss of control and can result in possible
serious injury.
3. Variable-Speed Trigger and Switch-Lock
Button (Speed Range Control Button)
Your reciprocating saw is equipped with a variable-
speed trigger switch (C) to turn the saw on and off
and to control the speed. The switch-lock button
(D) can lock the switch in the off position. It also
provides two speed ranges: "1" for low speed and
"2" for high speed.
a. To turn the saw ON, press the trigger-lock
button according to the speed range you need,
and then squeeze the variable-speed trigger
switch.
b. To turn it OFF, release the trigger switch. Press
the trigger-lock button to the middle position
marked
to lock the switch OFF and reduce
the chance of unintentionally starting the tool.
c.
To vary the speed within the speed range, simply increase or decrease the pressure on
the variable-speed trigger switch. The more the variable speed trigger switch is pulled, the
higher the speed will be.
3
10
D
C
D
Publicidad
