bloom luxo sleep Guia Del Usuario página 9

board, check the clasps are firmly locked and
the base board should be both secure and
perfectly flat.
– Side A has one single plastic guiding rail
that runs down each end panel's edge. See
illustration 6. Fixed side panel fits onto side A.
– (#04 fixed side panel) Slide the fixed side
panel onto the guiding rails located on side A
of the end panels.
– Side B has two separate plastic guiding rails
that run down each end panel's edge. See
illustration 5. Drop side panel fits onto side B.
– (#03 drop side panel) Note the drop side
panel has two trigger mechanisms on either
side of the top edge. Slide the drop side
panel onto the guiding rails located on side
A of the end panels. Slowly lower the panel
all the way down until locked into position,
you will hear an audible click. Ensure panel is
secure by pulling it upwards gently.
– NOTE: The side with the mattress level limit
mark faces to the inside of the baby bed.
Slowly lower the panel all the way down until
locked into position, you will hear an audible
click. Ensure panel is secure by pulling it
upwards gently.
– The bed assembly is now complete.
 To Lower Drop Side
– The drop side panel can be lowered for easy
access to baby.
– Simultaneously squeeze the two triggers on
the either sides of the drop side and slowly
slide panel downwards to the lower position,
you will hear an audible click.
– To raise the drop side panel to its original
position, squeeze the two triggers on either
sides of the drop side simultaneously, and
slowly slide panel upwards to lock into place.
You will hear an audible click. Ensure the
panel is secured in position by gently pushing
the panel downwards to check.
Note: Every time you leave the baby bed always
check that the drop side is returned to the
highest position.
WARNINGS
• WARNING: Discontinue use of the
product when child is able to climb out or
reaches the height of 0 cm / 35½ inches.
• WARNING: When child is able to pull to
standing position, remove bumper pads,
large toys, and other objects that could
serve as steps for climbing out.
Toddler Bed Set Up (without drop side)
To convert from baby mode to toddler mode
simply remove the Drop Side
Remove the drop side panel by squeezing the
two triggers on the either sides of the drop side
simultaneously, and slowly slide panel upwards
all the way.
Alternatively to set up in toddler mode, follow
the instructions below:
– (#01 frame) Fully extend the frame by pulling
end panels outward.
– (#02 base board) Place the base board within
the cot frame. Make sure correct side up
– the side with the warning labels is the top
eng