Descargar Imprimir esta página

LF Style SELECTIONS LWSMWU Instrucciones De Montaje página 3

Repisa de almacenaje para baño de 3 niveles

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
Step 1:
Align and attach top front stretcher (D), top back stretcher (E)
and towel bar (G) to the right-side frame (C) using 13 mm bolts
(AA). Securely tighten with the provided hex wrench (FF).
Hardware Used
AA
1/4in x 13 mm Bolt
FF
Hex wrench
Step 2:
Repeat the same procedure to attach left side frame (B) at
the opposite end.
Hardware Used
AA
1/4in x 13 mm Bolt
FF
Hex wrench
Step 3:
Attach top panel (A) to the unit with four 35 mm bolts (CC).
Make sure the back edges are flush with each other. Fasten
one shelf (F) to the middle rails of side frames (B and C) with
two 28 mm bolts (BB). Fasten the remaining shelf (F) to the
bottom rails of side frames (B and C) with two 35 mm bolts (CC).
Hardware Used
BB
1/4in x 28 mm Bolt
CC
1/4in x 35 mm Bolt
Hex wrench
FF
v
1
D
x 4
E
x 1
G
v
2
D
AA
E
x 4
B
x 1
v
3
A
F
x 2
BB
x 6
CC
x 1
5
ASSEMBLY INSTRUCTIONS
Step 4:
Locate and mark wood studs where the unit is to be installed.
Be sure to mount the unit on one horizontal wooden stud and
one vertical wooden stud. If no studs are available, or if the
wall is made without studs, it is your responsibility to choose
the appropriate hardware. The unit MUST be securely
AA
attached to the wall for safety and to be eligible for warranty.
Mark six mounting holes with a pencil as shown. Use a level
to ensure they are level and straight. Drill 3/16in pilot holes
C
at marked locations and insert the drywall anchors (GG) until
flush in the hole. Proceed to turn the pan head screws (DD)
into bottom four wall anchors. Leave the screw head stands
out 5 mm from the wall. NOTE: If the mounting hole coincides
with a wooden stud, use the attached pan head screw (DD)
only in this hole.
AA
Hardware Used
DD
M4 x 32 mm Wood screw
GG
Drywall Anchor
Step 5:
Ask for assistance to pick up the unit and position it to the
wall ensuring it is level and stable on the hardware.
F
AA
Step 6:
Secure the top back stretcher (E) to the inserted wall anchors
CC
with two 65 mm wood screws (EE).
BB
WARNING! Failure to properly secure the unit to
the wall can result in serious injury or death.
F
Hardware Used
EE
M5 x 65 mm Wood screw
4
Wall
x 4
v
5
x 6
DD
v
6
EE
x 2
6
GG
DD

Publicidad

loading

Este manual también es adecuado para:

1599725