VTech VM3263 Guia De Inicio Rapido página 3

What's in the box
1
Connect the baby monitor
NOTE NOTES
• The rechargeable battery in the parent unit is built-in.
• Use only the power adaptors supplied with this product.
• Make sure the parent unit and the baby unit are not connected to an electronically controlled
electric outlet.
• Connect the power adaptors in a vertical or floor mount position only. The adaptor prongs are not
designed to hold the weight of the parent unit and the baby unit, so do not connect them to any ceiling,
under-the-table, or cabinet outlets. Otherwise, the adaptors may not properly connect to the outlets.
• Make sure the parent unit, the baby unit and the power adaptor cords are out of reach of children.
Quick start guide
4
1 Connect the baby monitor (cont'd)
Charge the parent unit battery
When you have connected and turned on the parent unit, the battery will be charged
automatically.
Notes
NOTES NOTE
• Before using the baby monitor for the first time, charge the parent unit battery for 12 hours.
When the parent unit battery is fully charged, the battery icon segments are solid
• It takes longer to charge the battery when the parent unit is turned on. To shorten the charging
time, turn the parent unit off while charging.
• The standby time varies depending on the sensitivity level you set, your actual use and the age
of the battery.
The battery icon indicates the battery status (see the following table).
Battery indicators Battery status
The battery has very little
The screen displays .
charge and may be
The light flashes.
only a short time.
The battery icon segments The battery is fully charged.
are solid .
2
Power on or off the baby monitor
Connect the baby unit to a power
supply to turn it on. Disconnect the
baby unit to turn it off.
.
Action
Charge without interruption
used for (about 30 minutes).
To keep the battery charged,
connect it to AC power when
in use.
Press and hold to power on or off
your parent unit.
Press and hold
5