Publicidad
Idiomas disponibles
Idiomas disponibles
Set Up and Location
1)
Unpack humidifier from carton and remove all packaging material from the box.
NOTE: This unit has a natural stone tile inset. Take care when removing the
stone tile from the package, as it is breakable and heavy.
2)
Lift up the chassis (upper cabinet) to locate the casters and manual.
3)
Place humidifier on a flat level surface. Position the humidifier where the most
humidity is needed or where the most air will be circulated throughout the house
such as near a cold air return. If the unit is positioned close to a window,
condensation may form on the window
pane. If this occurs the unit should be
repositioned in another location.
NOTE:
Due to release of cool, moist
air from humidifier, it is best to direct air
away from thermostat and hot air
registers, and to position humidifier next
to an inside wall. Unit should not be
placed where cold air from outside walls
or warm air from a hot air register blows
directly on it.
3)
Place the humidifier at least 2 inches
from the wall or curtains.
Assembly
CASTERS
1)
Lift chassis off of base and set aside.
2)
Remove float and wick/wick retainer from base. Turn the empty base upside
down. Insert each caster stem into a caster hole on each corner of the
humidifier bottom. The casters should fit snugly and be inserted until the stem
shoulder reaches the cabinet surface.
3)
Turn the base right side up.
EVAPORATIVE WICK
4)
Ensure the 1043 Superwick is
installed in the two-part wick retainer
base in the base of the humidifier
5)
Position the chassis over the base
frame and press it onto the base
firmly until it is in place.
6)
Ensure the chassis is placed on the
base with the float facing forward.
All manuals and user guides at all-guides.com
5
Publicidad
