Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly.
1
Motor Base
Place the
a dry, level counter top.
Ensure the dial is set to the
"OFF"
position and the unit
is unplugged.
3
Sieve
Align the
with the
motor drive coupling and
push down until it clicks into
Sieve
place. Handle the
by gripping the top edges
being careful not touch the
sharp teeth on the base of
the Sieve. Ensure the
Sieve
is properly seated in place
and securely inside of the
Pulp Basin.
10
2
on
Place the
Pulp Basin
of the Motor Base. Align the
Pulp Basin
with the Motor
Base so that the spout is
aligned with the dimpled
side of the Motor Base.
4
Basin Cover
Place the
over the Sieve and Pulp
Basin. The side "ears" on
Basin Cover
the
should
align with the "ears" on the
sides of the Pulp Basin.
5
on top
Raise the
and move it into the "ears" on
each side of the Basin Cover.
The
be in a vertical position and
locked into place.
NOTE:
securely in place, the juicer will
not power on.
7
Place the
Lid
Pitcher and open the
locking lid latch.
6
Locking Handle
Locking Handle
should
Locking Handle
if the
is not
8
Juice Pitcher
on top of the Juice
Swing the
No-Drip Spout
cover up vertically, so that
it is no longer covering the
juice spout.
Juice
Slightly angle the
Pitcher
and place it under
the juice spout. Align the
spout with the hole in the
Juice Pitcher Lid
and level
Juice Pitcher.
out the
It will
fit snuggly into the spout to
hold it in place.
11
Publicidad
