Publicidad
Idiomas disponibles
Idiomas disponibles
2. Brush speed control – The brush rotation speed can
be set in 2 settings: slow mode of 800 rpm (for smooth
surfaces) and fast mode of 1000 rpm (for rough surfaces).
The appliance is default set in fast mode. Press the speed
control button, the slow mode indicator will light and the
appliance will run in slow mode. Press the speed control
button again to change to fast speed.
3. Error indicator – The error indicator will flash in red to
indicate overcurrent, and the appliance will automatically
shut down.
Starting the Cleaner
1. Make sure the patio cleaner is connected with a
proper water source. Slide the battery into the battery
compartment until it clicks and locks into position
(Fig. 12).
Fig. 12
Battery pack
2. Turn the water supply tap on completely.
3. Determine the direction you want to clean and adjust the
spray wands accordingly. Rotate the spray wands to the
back of the machine to clean the rear area. Rotate the spray
wand to the front of the machine to clean the front area.
Rest the spray wands in the slots located on the front and
the back of the machine (Fig. 13).
Fig. 13
Spray
wands
Front slot
4. Make sure the water flow regulation valve is set to the
minimum flow position (front), press the safety lock button,
and squeeze the On/Off switch. When the appliance is
running, release the safety lock button (Fig. 14).
Fig. 14
Safety lock button
On/Off switch
5. Use the control panel to set the appliance in desired
direction and brush speed. If the rear area needs to be
cleaned, set the appliance in backward mode (Fig. 15).
If the front area need to be cleaned, set the appliance in
forward mode (Fig. 16) Make sure the spray wands are
placed in the corresponding position.
Fig. 15
CLEAN THE REAR AREA
Back slot
12
Spray wands
Backward
mode
Publicidad
