MOTION BLINDS CM-06 Manual Del Usuario página 19

Save a new favorite position
11
To remove your previous favorite position you need to place your blind
at your current favorite position. (Step 10) Then Hold the pull until
the blind steps up and down once. (Approximately 7 seconds) Your
favorite position is now removed. Follow step 9 to set your new favorite
position.
7 s
Deactivate direct control for remote control (Not recommended for Venetian)
When pressing the up or down button on the remote control, the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be deactivated. Now, the blind only directly moves to its end
positions when the up or down button is held longer than two seconds.
Press the program button on the motor to activate program mode. The blind starts stepping.
.1
Hold the program button until the blind stops stepping (approximately 5 seconds)
.2
to deactivate or reactivate direct control.
Short
press +
5 s
19