Kohler K-T609 Guia De Instalacion página 8

Sleeve
Handle Assembly
Screws
Screw
Large Bearing
Short Stem Extension
Small Bearing
Long Stem Extension
Washers
5. Install the Faceplate and Handle
Remove the sleeve from the handle assembly.
Set the sleeve into the center of the shroud with the screw holes
aligned.
Secure the sleeve with two screws.
If you have a thin wall installation, remove the large and small
bearings from the long stem extension.
Reinstall the large and small bearing and washers onto the short
stem extension.
Secure the chosen stem extension into the handle assembly with a
screw.
Thread the handle assembly over the sleeve, and securely hand
tighten.
1023658-2-B 8 Kohler Co.