Gecko G200 Guia Del Usuario página 6

ASSEMBLY
Extend the telescopic rod and close the fixings
Push in the telescopic rods
Place the steam diffuser
Place hanger supports and hanger
Opening: press and turn
counterclockwise
water filling 1L max.
Press the on/off button to the
ON position
English
Screw the safety cap:
press and turn clockwise
10
INSTRUCTIONS FOR USE
Start-up
Fill the heating tank without exceeding the limit set at 1 liter of water.
Close the safety cap carefully without overtightening.
Ensure that the diffuser is correctly placed on its support. Plug in the
power cord.
Press the on/off button
Wait for the "steam ready" indicator light to come on
before pressing the steam outlet button
Residual water droplets may be propelled during start-up.
Warning: if the heating tank contains too much water, the device will spit
out the excess water when the steam button is pressed. If you notice this
phenomenon, let the excess water escape over a container (be careful of
splashing hot water). The phenomenon will disappear once the level returns
to normal.
Water filling
Wait for the tank to cool completely before opening the
filling cap.
When the device no longer produces steam,
• Disconnect the device from the electrical network
• Slowly unscrew the safety cap. Before unscrewing it
completely, wait until the hissing sound created by the residual steam
disappears.
• Use the graduated container with the funnel to fill with a maximum of
1 liter of water
• Screw the safety cap without tightening too tightly
• Connect the device to the electrical network
Shutting down the device
Store the steam diffuser in its holder
Press the on/off button to the off position
Disconnect the device from the electrical network
11
English