Whirlpool Bauknecht HD524 Guía De Referencia Diaria página 5

LOADING THE RACKS
UPPER RACK
(loading example for the upper rack)
ADJUSTING THE HEIGHT OF THE UPPER RACK
The height of the upper basket can be adjusted: high position to
place bulky crockery in the lower basket and low position to make the
most of the tip-up compartments by creating more space upwards.
The upper rack is equipped with a Upper Rack
height adjuster (see figure), without pressing
the levers, lift it up by simply holding the rack
sides, as soon as the rack is stable in its upper
position. To restore to the lower position, press
the levers (A) at the sides of the rack and move
the basket downwards.
We strongly recommend that you do not
adjust the height of the rack when it is
loaded.
NEVER raise or lower the basket on one side only.
FOLDABLE FLAPS WITH ADJUSTABLE POSITION
The side foldable flaps can be fold or
unfold to optimize the arrangement of
crockery inside the rack.
Wine glasses can be placed safely
in the foldable flaps by inserting
the stem of each glass into the
corresponding slots.
Depending on the model:
• to unfold the flaps there is needed
to slide it up and rotate or release it
from the snaps and pull it down.
• to fold the flaps there is needed
to rotate it and slide flaps down or pull it up and attach flaps to the
snaps.
Load delicate and light dishes:
glasses, cups, saucers, low salad
bowls.
LOWER RACK
For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids
should ideally be placed at the sides to avoid interferences with the
spray arm. The lower rack has tip-up supports which can be used in a
vertical position when arranging plates or in a horizontal position (lo-
wer) to load pans and salad bowls easily.
(loading example for the lower rack)
CUTLERY BASKET
The basket is equipped with top grilles
for improved cutlery arrangement. The
cutlery basket should be positioned
only at the front of the lower rack.
Knives and other utensils with sharp
edges must be placed in the cutlery
basket with the points facing down-
wards or they must be positioned
horizontally in the tip-up compart-
ments on the upper rack.
EN
5