WARNING
● Important safety instructions. Follow all instructions, since incorrect installation can lead to severe
injury. Before installing the drive, remove any unnecessary cords and disable any equipment not
needed for powered operation.
● Install the actuating member of a manual release at a height less than 1.8 m.
● A horizontal distance of at least 0.4 m is to be maintained between the fully unrolled driven part
and any permanent object.
● This awning is heavy.
● Three people are required to lift the awning into position once the brackets are fitted to the wall.
● DO NOT attempt to lift the awning unit into position without assistance as dropping the unit is
likely to cause serious damage to the product and could result in serious injury.
● DO NOT allow children or pets to play in the working area during assembly and fitting.
● Keep the transmitter out of children's reach at all times after the awning unit is fitted.
● Ensure your hands are kept clean during fitting; this will prevent the awning fabric and frame
becoming dirty.
● The awning frame is supplied with a clear plastic wrapping.
● This should be removed after fitting.
● Plastic bags used in the packing of this product can be dangerous to children and babies.
● Keep out of the reach of babies and children to avoid risks of suffocation.
Before assembly
Check whether the delivery has any transport damage and whether the box contains all the
components listed on the enclosed parts list. Please contact your service representative if you
notice that any parts are missing or damaged.
Only install the awning if you have sufficient experience in occupational safety and in handling
the necessary tools.
Before fitting, ensure that the building structure has sufficient load-bearing capacity. In case of
doubt, we advise you to consult a specialist.
Avoid the risk of electric shock by working carefully on the cables and disconnecting the
awning from the power supply beforehand.
Please ensure that the awning does not open unintentionally while you are working on it.
When you extend the awning for the first time, avoid standing under the awning.
We do not accept any liability for the load-bearing capacity of your wall and the correct instal-
lation.
Of course we check the awning before shipping and adjust it correctly in advance, but it
must be adjusted again after installation. In this way the adjustment options can be precisely
matched to each other to ensure the best possible guidance of the awning. Since all adjust-
ment possibilities influence each other, patient work is necessary.
EN
INSTALLATION STEPS
11
KEN002VKM
v1a • 17.04.2020